Thingiverse
Vileda Bottle Holder
1
Download
0
Likes
0
Makes
The bottle holding clip on my Vileda became dry and brittle over time and eventually, right after clicking the bottle in place, it popped out and the bracket broke.
It's been over 2 years now and I was tired to hold the bottle down to spray, so I drew a new one, so over 6 hours of design and few prints (first ones were not fitting great), I've got a new, functional HIGHLY structural and solid.
Hopping it will help someone, I waited 2 years because I was not able to find it already done, so here you go :D
I printed it in 0.3mm since I didn't want to wait 6 hours. The part is very strong and I don't think you need more printing quality since it's not a part you see.
Suggested material: PETG
Suggested layers: 0.3mm
Suggested infill: 100%
It's been over 2 years now and I was tired to hold the bottle down to spray, so I drew a new one, so over 6 hours of design and few prints (first ones were not fitting great), I've got a new, functional HIGHLY structural and solid.
Hopping it will help someone, I waited 2 years because I was not able to find it already done, so here you go :D
I printed it in 0.3mm since I didn't want to wait 6 hours. The part is very strong and I don't think you need more printing quality since it's not a part you see.
Suggested material: PETG
Suggested layers: 0.3mm
Suggested infill: 100%
Hai stampato questo modello? Accedi e condividi il tuo make!
Accedi per lasciare un commento
AccediAncora nessun commento – sii il primo!
