Vinyl Cover Wall Mount

A small vinyl cover mount that can be attached to your wall. Double sided tape seems to be enough to secure two of these to your wall as vinyl covers are pretty light to say the least - however I haven't left a case with a vinyl inside on this for a long period of time. If in any doubt, print the longer model which has an extra 20mm on the contact surface for better adhesion. NOTE: If your print flares/skirts around the edges leaving an non-uniform adhesion surface, apply the tape and remove the backing, then apply more tape to build up a thicker tape layer, or file it flat. You could even chuck a nail through it for good measure.

The part itself is very strong with a 20% infill and a .8mm wall thickness, and could probably be made thinner, however I am happy enough with the initial print so have not done this.

A countersunk bore can be added if anyone wants this screwing to their wall rather than taped, but I honestly don't think this is necessary.

1x wall mount takes around