MakerWorld
Other Hobby & DIY
Go to Model
Vinyl Wall Mount
65
Downloads
18
Likes
43
Makes
This is a Vinyl wall mount. It is made to be held up by two screws. (command strips might work too, though I never tested it out). when screwing in the mount, just make sure it is snug, do not overtighten it as it is still made of plastic. There is a clip that comes with it. It is not required as it only helps the vinyl sleeve/jacket from puffing outwards when laying on the mount.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
