Virtual Reality Sensor Wall Mount

A friend needed a 45º corner wall mount. I could not find one so I designed it for him. I've included a mount for a straight wall. The insert can fit both mounts. Printing time for a corner mount and the insert together is roughly around 5 hours using 84% fill on the Afinia H480.

To mount in the wall, first drill appropriate size hole for nail or screw. Mark holes on the wall where mount is too be placed and the drill screw or hammer nail through the holes in mount and into the wall.

One can also use the "Command Strip" on the back of the mounts to avoid holes in the walls.
Be sure to use heavy type to bare the weight of not only the sensor but the cable as well.

NOTE: These designs is free to use at your own risk. Venturon's and it's designers are not responsible for damages or injuries caused to walls, sensors, or to persons involved.