Thingiverse
Vise Soft Jaws
door UnitedMi
6
Downloads
6
Likes
0
Makes
Designed to fit over existing jaws which are 3.75in x 1in and 5/16 in thick. They are held in place with magnets glued in with Loctite GO2 Glue (I've had hit or miss with other glues and like that the best). 0.03 in over sizing is added to each side for a better fit.
The knurling was done by cutting a 90 degree "V" 1/32 in down at a 45 degree angle, then doing again perpendicular to that.
The knurling was done by cutting a 90 degree "V" 1/32 in down at a 45 degree angle, then doing again perpendicular to that.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
