Thingiverse
Visual colour egg timer for #CountertopChallenge
von P4LIL
9
Downloads
12
Likes
0
Makes
a 3d printed electronic colour egg timer, rotate to select hard or soft, times set in code. designed for the #CountertopChallenge
video https://youtu.be/_Izagx-EP9M
3d printed egg timer, uses attiny 85 and 3 x ws2812 LEDs to time either a hard or soft boiled egg. Times are set in software. A tilt sensor detects which way up the egg is to set the timing. The device is powered by 3 x AA batteries in sprung loaded holders inside the egg. When not in use it is put to sleep and draws very little power.
The sequence is fade to colour to show hard or soft, then the LEDs light in sequence changing colour from blue to orange, and the speed increases until the set time is reached when it flashes 5 times and hopefully the egg is cooked perfectly!
A bit more work needs to be done on the detector code, and maybe it needs another tilt sensor at 180degrees to unambiguously detect the way up it is.
video https://youtu.be/_Izagx-EP9M
3d printed egg timer, uses attiny 85 and 3 x ws2812 LEDs to time either a hard or soft boiled egg. Times are set in software. A tilt sensor detects which way up the egg is to set the timing. The device is powered by 3 x AA batteries in sprung loaded holders inside the egg. When not in use it is put to sleep and draws very little power.
The sequence is fade to colour to show hard or soft, then the LEDs light in sequence changing colour from blue to orange, and the speed increases until the set time is reached when it flashes 5 times and hopefully the egg is cooked perfectly!
A bit more work needs to be done on the detector code, and maybe it needs another tilt sensor at 180degrees to unambiguously detect the way up it is.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
