Thingiverse
Vitaly
by volkodav
0
Downloads
3
Likes
0
Makes
Fastening of the SJ4000 camera on 2 axial suspension for installation on a kopter.
The press is possible both PLA, and ABS. On a photo – option from black ABS. After listing we put model to a suspension and we drill below in the place two openings under 2 mm screws.
The press of PLA and ABS is possible (I checked both options).
The press modes - standard for plastics.
Filling - 100% (there walls from 1,6 to 2 mm).
On option with a horizontal latch more plastic - since more supports leaves.
The press is possible both PLA, and ABS. On a photo – option from black ABS. After listing we put model to a suspension and we drill below in the place two openings under 2 mm screws.
The press of PLA and ABS is possible (I checked both options).
The press modes - standard for plastics.
Filling - 100% (there walls from 1,6 to 2 mm).
On option with a horizontal latch more plastic - since more supports leaves.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!