Vitamix Tamper Holder

The tamper holder just slides on to the bottom of the Vitamix. No other attachment is needed.

There are two versions of the STL file. One with the Vitamix raised on 5 mm felt pads under the feet (VTHWP) and one with no pads (VTHNP).
Either version of the STL file assumes a thin 2 mm pad under the tamper holder to prevent scratching and provide some buffer space.

The VTHWP version is useful if you slide your blender around on the counter or from under overhead cabinets. I use this version myself.

I printed this at 0.3 mm layer height and 0.5 mm layer width using PETG filament.
No clean up usually required when printing at a slower speed.