Thingiverse
Vive Headstrap support - MOD-T capable print
von nIkbot
3
Downloads
5
Likes
0
Makes
This is slight remix of the Vive headstrap holder....
I found it would not print on my MOD-t due to the thin lowest wall. I increased this to a wall thickness the MOD-T can print.
I have yet to get home to see the fit on the Miller electric welding helmet, seeing how this original model was designed for a Jackson Safety helmet. It should still fit the same, as the straps on the Miller are narrower than the Jackson.
I will report back later on the fitment and re-upload adjusted files if needed.
I found it would not print on my MOD-t due to the thin lowest wall. I increased this to a wall thickness the MOD-T can print.
I have yet to get home to see the fit on the Miller electric welding helmet, seeing how this original model was designed for a Jackson Safety helmet. It should still fit the same, as the straps on the Miller are narrower than the Jackson.
I will report back later on the fitment and re-upload adjusted files if needed.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
