Vive magnetic controller dock

A 'finished product' version of these is now available to buy at http://www.vrmagdocks.com, but you are welcome to keep using this model.

This uses these cables:
https://www.amazon.co.uk/gp/product/B01CZMLQSK/ref=oh_aui_detailpage_o02_s00?ie=UTF8&psc=1

And is an EXACT fit. If your printer doesn't print very high quality then make sure you pint out these parts first.

The run for the cable is also very tight, so check this as well. I have painted these after printing, but it might be easiest to break the model down if you want different colours, painting as one piece was a pain. It will also make it easier to print if you break it down into pieces.

The little right angle thing is a plug that should slot in to cover the gap where the wire goes in. I think it might need shrinking a touch to fit properly however, I've not tested it yet.
Good luck, let me know if you have any problems!