Vive Ultimate Tracker - 3 Tracker Charging Base

Simple Vive Ultimate Tracker 3 tracker charging base

THIS IS A PROTOTYPE AND AS SUCH HAS ROUGH EDGES AND/OR MAY REQUIRE SOME SLIGHT MODIFICATION

This is designed for use with the following PD (Power Delivery) board:

PD Board (Amazon)

Use of a different board may require alterations to the design of the carriage holding the board.

The following files are contained in this project:

Vive Ultimate Tracker Charging Base (Top)
Vive Ultimate Tracker Charging Base (Bottom)
Vive Ultimate Tracker Charging Base (TPU Interface)

Of these, only the first two are explicitly required for completing the project; the TPU interface may be added for a bit of slip-resistance for the bottom of the device but is not required.

Additionally, a length of small-gauge wire with insulation, 6 spring-loaded spherical pins, and a soldering iron + solder are also required.

Instructions for assembly





For printing I used a Creality CR-10SE with Creality Hyper PLA, and Inland TPU