VoidMicro Engraver-O Field Upgrades!

Laser Engraver Field Upgrades!
Expanded Area Upgrade!
Air Assist Upgrade!
Laser Height Upgrade!

I recently acquired a cheap laser off of Ebay. The listing didn't provide details, but it turned out i was purchasing a VoidMicro Engraver-O (LC2429O) which is fine. I got what was in the pictures, and after a day or two of finagling, I figured out how to use it properly.

HOWEVER, this laser was designed really inefficiently! I didnt take pictures before the change, but it's original design is well documented on their website

(http://voidmicro.com/Manual/OMachine-en.html?page=page_Manual)

I tried to use as much of the original screws and stuff as i could, but some additional screws will be required. Specifically M10 and M3 Screws and Nuts.
If something looks similar in how it mounts to the original hardware, that's because it is. this should be intuitive

ISSUE ADDRESSED 1 OF 3, The manufacturer claims a print area of 240mm x 290mm. (I don't think I was getting even that!),