Volcom Snowboard Stomp Pad

Quick copy of the Volcom Stone Snowboard Stomp Pad set, lost one of my originals.
(Top Centre in photo is Volcom origional)

This was a Polycarbonate Test (Hobby-king black PC)
Enclosed Stock CR-10 (with some mods In marlin flashed to allow High Temps and Mesh levelling)
Nozzle 0.4
Extrusion Multiplier 1.0
Retract distance 5mm
Retract speed 30mm/s
Bed temp 100
Hot-end 280 first layer, 275 for rest of build
Top and bottom 4 layers
Outer shells 5
First Layer 91 %
Cooling 0
Layer Hight 0.2
Infill 30% Fast Honeycomb
Print Speed 40 mm/s
Supports 0
Simplify 3D


Using Stock CR-10 Hot-end with Capricorn Bowden tube.(Best upgrade you can buy)
Tuned Stock Power Supply to 13 Volts ( see youtube for this stock mod it will allow your
heat-bed to heat quickly and achieve 100* Plus)

I Don't see any reason Why PLA or ABS would work for this. It would be defiantly easier
than printing Polycarbonate. Its a short build so bump up your infill.

Because it was pollyca