Thingiverse
Voltaic Spear (Guild Wars Skin)
by 3ideal
27
Downloads
23
Likes
0
Makes
Model of one of the rarest GW1 weapons.
You might want to adjust the scaling for a bigger model. Support should be enable to print the shaft of the spear straight. Print the spear flat on the printer bed!
Infill and Layer height should be adapted to the chosen scaling factor. But since this is a simple model, a fine resolution is recommended.
Enjoy!
You might want to adjust the scaling for a bigger model. Support should be enable to print the shaft of the spear straight. Print the spear flat on the printer bed!
Infill and Layer height should be adapted to the chosen scaling factor. But since this is a simple model, a fine resolution is recommended.
Enjoy!
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
