Thingiverse
Electronics
Go to Model
Voltmeter or Temperature Display Enclosure
138
Downloads
89
Likes
0
Makes
I was looking for an enclosure/holder for a voltmeter and temperature display, but couldn't find anything existing that was what I was looking for. I built these to screw onto the side of my printer enclosure (Stuva cabinet from IKEA).
To install, just snap the display into the enclosure and screw the enclosure onto whatever surface you'd like. I drilled a hole to run the wires through and then installed the display, so the hole is hidden.
The displays I purchased and used were:
Voltmeter: http://www.dx.com/p/203339
Temperature: http://www.dx.com/p/417909
They are identically sized, obviously.
To install, just snap the display into the enclosure and screw the enclosure onto whatever surface you'd like. I drilled a hole to run the wires through and then installed the display, so the hole is hidden.
The displays I purchased and used were:
Voltmeter: http://www.dx.com/p/203339
Temperature: http://www.dx.com/p/417909
They are identically sized, obviously.
xiaosen also publishes on
4 additional models across 1 more platforms
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
