Thingiverse
Volvo armrest P2
0
Downloads
1
Likes
0
Makes
fix for the volvo armrest in pre facelift P2 models, simply glue in place with glue, i use quick glue, very cheap and good bonding with ABS
it is made to support the whole armrest bij giving it more coverage in the width and also resting on the underplate giving it extra strength.
they are both the same print, i recommend first test fitting before glueing. in my case i had to shave a little bit of the top because of a crack repair i made earlier.
keeps the original look
NO DRILLING OR EXTRA SCREWS REQUIRED
1.0 mm thick walls and floor
20% infill with gyriod
14 Grams of filament
Volvo P2
Volvo S60 2000-2004
Volvo V70 2000-2005
it is made to support the whole armrest bij giving it more coverage in the width and also resting on the underplate giving it extra strength.
they are both the same print, i recommend first test fitting before glueing. in my case i had to shave a little bit of the top because of a crack repair i made earlier.
keeps the original look
NO DRILLING OR EXTRA SCREWS REQUIRED
1.0 mm thick walls and floor
20% infill with gyriod
14 Grams of filament
Volvo P2
Volvo S60 2000-2004
Volvo V70 2000-2005
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
