Voron 0 Transportation Solution

Since I occasionally need to travel with my Voron 0.2, I needed a solution to secure the printhead and bed during transport.The parts are designed to fit the 1515 Formbot and Makerbeam XL profiles. You can adjust the files to fit your specific profiles if needed.The clamp for the printhead attaches to the two profiles of the Z-axis, while the clamps for the bed attach to the profile above the LCD.There are two versions of the clamps:Use M3x12-16mm self-tapping screws (4 pcs).Use Voron heat inserts (3-4 pcs) and standard M3x12-16mm screws.Additionally, I created some macros and LCD menu entries to enhance usability:Move the printhead and bed into the transport position:If you have neopixels installed in your printhead, for example, they will flash red to indicate that the printer may not be ready for printing.Transport mode warning:When you turn the printer back on, if you haven’t reset the transport mode, the neopixels will flash again to remind you to check and remove all clamps.Reset