Voron 1.5 Mods

This is where I'll be putting all of my mods to the Voron 1.5 design. Here you'll find:

Part Cooling Mods: Replaced the dovetail joinery with m3 hardware and added a bit more room for wires to run between the carriage and fan mount. Also included an extended harness mount with an extra set of zip tie holes.

A/B Idler Mods: Meant to add further reinforcement and prevent the idlers from splaying apart when attached to the printer frame and keeping the flanged ball bearings snug together.

Hardware for Assembly:

Part Cooling:
2 x M3 20mm Socket Head Cap Screw
2 x M3 Hex Nuts

Idlers:
2 x M3 30mm Socket Head Cap Screw
2 x M3 Hex Nuts
Nylon standoffs optional, but recommended.

Check out the Voron community and github:
https://www.reddit.com/r/voroncorexy/
https://github.com/mzbotreprap/VORON