Voron Cube Lamp

BOM- USB-C cable- WeMos D1 mini or clone- 90mm 24 LED ring- A bit of 24AWG-ish wire- Hot glue gunI've printed the cube part in vase mode with 0.8 walls. All other settings were left at whatever Orca suggested for the vase mode (ended up with 3 bottom 0.2 layers)Assembly- Solder 3x 40mm wires to 5V, GND and D4 pins on the WeMos board- Solder the other ends to the LED ring (5V, GND, DIN)- Isolate bare contacts with hot glue- Place LED ring and WeMos board into the stand- Add a bit of hot glue to hold everything together- Connect WeMos board to your computer and open https://install.wled.me/ in your Chrome browser- Flash Plain version of WLED onto the board- Connect WLED to your Wifi and in WLED settings make sure you're using GPIO pin 2 and set the number of LEDs to 24This is a very straightforward build but if you see how this instructions can be made better please let know :Voron_Heart: