Thingiverse
Voron Magnetic Panel Mounts
by Jfearnside
7
Downloads
0
Likes
0
Makes
Magnetic mounts for Voron 2.4 panels. These hold on very securely, you could probably cut down the number of magnets if needed.
This is a remix of 'latte1989' magnetic mounts.
Note - this does leave a gap around your panels that air can pass through. I have added panel edging that snaps into the 2020 extrusions around the panels. This helps seal the panels to keep warm air in the print chamber. Length can be altered by scaling on one axis only in your slicer.
BOM (per panel):
16x M3 Socket screws - 6mm
72x 6*3 round button magnets
16x M3 2020 Series T-Nuts
This is a remix of 'latte1989' magnetic mounts.
Note - this does leave a gap around your panels that air can pass through. I have added panel edging that snaps into the 2020 extrusions around the panels. This helps seal the panels to keep warm air in the print chamber. Length can be altered by scaling on one axis only in your slicer.
BOM (per panel):
16x M3 Socket screws - 6mm
72x 6*3 round button magnets
16x M3 2020 Series T-Nuts
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
