Voron Raspberry Pi v2.1 Camera Mount

Simple mount for the Raspberry Pi v2.1 Camera for a Voron 2 printer. It should work equally well for most printers based on standard 20x20 extrusions with a Raspberry Pi running OctoPrint. Since the best view on the Voron 2 is from the front, but the doors need to remain openable, it easily rotates down for access, then rotates back up for printing and recording. You can also rotate the camera left to right and up and down to get the right angle, as well as to install it anywhere along the front bottom rail (except right in the middle). It could also be installed on the side of the frame if you like but the gantry will block much of the view.

Parts required for assembly:

* (2) 3mm x 6mm thumbscrews
* (6) 3mm x 8mm cap head screw
* (1) 3mm square nut (for the left-right rotation clamp)
* (5) 3mm x 5mm (OD) x 3 or 4mm height thermal inserts
* (2) 3mm hammer head t-nuts
* (1) Raspberry Pi Camera v2.1
* (1) 24" Extended Raspberry Pi Camera Cable
* Plastic glue (e.g. cyanoacryl