Thingiverse
Voron spool holder extended.
von docah
6
Downloads
4
Likes
0
Makes
A remix of the original Voron 2.4 spool holder for Polymaker 3kg spools.
As most of the printers in the world are not voron, i should note the following:
You will need a length of PTFE tubing to run in the channel that faces up after installation on your printer. This will smooth the rolling of spools. (PTFE is very slippery)
You will need an M5 bolt and M5 t-nut for the 2020
As most of the printers in the world are not voron, i should note the following:
You will need a length of PTFE tubing to run in the channel that faces up after installation on your printer. This will smooth the rolling of spools. (PTFE is very slippery)
You will need an M5 bolt and M5 t-nut for the 2020
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!