Voronoi Raspberry Pi 3B+ Case

Staved off the convert to Octoprint for 5 months, wanted a slim adaptable case for various mounting positions in my enclosure. Loved the original Voronoi design but hate using hardware to assemble, redesigned for a snap fit enclosure and base mount.

Remix: https://www.thingiverse.com/thing:3668358

Bottom cover is mounted by either screwing in place or snapping into the mount. If you do mount through the bottom cover, pins on the underside of the board may have to be trimmed and covered. Bottom cover and lower mount accept M3 hardware,

When used in combination with the base mount the raised guard edge keeps the tabs closed for the cover. Support pins and edges are in the bottom cover keeping the PCB raised and support pins are extended down from the to cover locking the PCB in place.

Two versions of top covers are available, with and without a fan mount. All IO pins, display and camera ports are open through the top. Fan mount is designed for a slim 2.1mm nut to be pressed i