Vortex 150 storage box

Storage box for Immersion RC Vortex 150 Quad.

I needed a way to keep from damaging my Vortex 150 when transporting it in a duffle bag and as a method of storing it while being able to stack things on top of it.

*Warning--- this box takes up almost a whole 200x200 bed so if possible print on a large machine but can be done on a 200x200 . On my Wanhao Di3 I had to tape the glass build plate down just to print it because the clips would get hit by the cooling fan shroud and nozzle. Not having the build plate held very well did cause some issues with

I made the box rather beefy, so it takes some time to print and uses a good bit of filament but it's sturdy so far. I glued a piece of 2"/50mm foam to the center of the top to hold the quad in place better and eliminate the quad flopping around to much. The foam holding the VTX ant is an extra piece of foam I had

Feel free to re mix for other similar quads.