Thingiverse
vortex mixer for spray paint
by Kmskelton
9
Downloads
7
Likes
0
Makes
NOTE: this is probably a bad idea. Print and use at your own risk.
This is a vortex mixer for full sized cans of spray paint. It needs a drill with a half inch chuck. I spin the cans for about a minute and the spray has been consistently good on my terrain and minis.
Print this in the orientation provided. Use large layers with hot filament to get the best layer adhesion you can.
This is a vortex mixer for full sized cans of spray paint. It needs a drill with a half inch chuck. I spin the cans for about a minute and the spray has been consistently good on my terrain and minis.
Print this in the orientation provided. Use large layers with hot filament to get the best layer adhesion you can.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
