Slicer Discord
VR 18650 battery pack – 3D-printbaar model van Thingiverse Thingiverse

VR 18650 battery pack

1 Downloads
1 Likes
0 Makes
Model downloaden
Headset battery pack to extend wireless playtime. Uses 8 18650 batteries for a roughly 12 hours wireless play time. Was designed to fit the straps for the oculus quest 1, with rivets, but may fit onto other headsets.

There is a bolt on PCB case for an input/output typeC charger. The oculus quest is noted for not charging fast enough to keep the battery topped off through the type c port though, so I actually ended up gutting my quest to remove the internal battery above the forehead and directly hard wired in my 18650 cells, thus the PCB is just used as a charger. Its important to not charge it through the Oculus type c if its in this configuration since the internal oculus battery is a different chemistry that tops off around 4.5V instead of 4.2V and will try to overcharge the 18650s.
Bron
Thingiverse
Wat je nodig hebt om te printen: Gemiddeld Lage betrouwbaarheid
Eendelig Hardware nodig
Supports 1/3
Montage 0/3
Instellingen 1/3
Bedgrootte 0/3
Nabewerking 1/3
Printer
FDM / FFF
Bestandsformaat
STL
Materiaal
PLA, TPU, Polycarbonate
Geschatte printtijd
12 h
Nabewerking
Hardware
Software
Cura, PrusaSlicer of vergelijkbaar
Nog geen beoordelingen
Nog geen reacties – wees de eerste!

Vergelijkbare modellen

6 Suggesties
Feed Blog Slicer Kostenrekenmachine Zoeken op afbeelding Indienen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Toevoegen aan collectie