Thingiverse
VS4-10 Phoenix spring collar
von Guden79
22
Downloads
13
Likes
0
Makes
If there were problems with Vanquish Products S4-10 Phoenix spring collars, I had to make my own.
Printed with a layer height of 0.1mm and 100% filling.
Since the kit is still on the way to me, I was only able to measure with GTS dampers from the TRX4, but since the spring caps from the GTR dampers also fit on the Phoenix, it should work.
Printed with a layer height of 0.1mm and 100% filling.
Since the kit is still on the way to me, I was only able to measure with GTS dampers from the TRX4, but since the spring caps from the GTR dampers also fit on the Phoenix, it should work.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
