Thingiverse
VTOL Valkyrie Wing Conversion
by VooDooMoN
98
Downloads
61
Likes
0
Makes
This is a model I made for myself about 3 years ago. I tried selling them elsewhere on the web but based on user demand, I decided to just release them under a non-commercial licence.
Each wing requires 2 duct prints and a single jack print.
It took me about 6 hours of sanding/wet-sanding a single pair of wings to get them to match the texture of the model. I would highly recommend LOTS of post-processing to get the pieces to look perfect before priming/painting.
One last note: this model requires cutting your Valkyrie wings down a lot and the amount I cut away was pretty much all done by eye.
Each wing requires 2 duct prints and a single jack print.
It took me about 6 hours of sanding/wet-sanding a single pair of wings to get them to match the texture of the model. I would highly recommend LOTS of post-processing to get the pieces to look perfect before priming/painting.
One last note: this model requires cutting your Valkyrie wings down a lot and the amount I cut away was pretty much all done by eye.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
