Vufine Dock Mount

I don't have very flexible filament, but I wanted to print this. I managed to modify it smaller so I don't need to print the "sticky" parts and glue in a 1mm thick magnet I had found in some "nice" packaging that used magnets. I didn't realize that the vufine has 2 magnets in it for stability reasons, so this mount may need to be redesigned.

I printed this with Ninjatek Armadillo since that's the only TPU I have. The strap is a bit stiff, may need to thin it out a bit... but otherwise, it holds onto my Oakley's Five's Squared, which was the main goal.

I like this mount way better than the ball joint one. That one is terrible, I just need to find a way to keep my vufine from sliding down with the current... might redesign it again.

Need to find more small magnets.