VW Golf Shifter with 5-Speed Pattern

This is a remix of the Golf shifter for a MK1 VW Rabbit. I cut a 5-speed pattern into the top of it, painted the numbers, and then filled the top with clear resin. I then post-cured the whole thing for about 20 minutes before sanding with 1500 grit sandpaper and sprayed it with Krylon clear coat. Make sure the resin is fully cured before you paint, because clearcoat blocks a lot of UV, so it won't really cure after you paint it. Or just print it and throw it on. I'm not your boss. You do you.

I didn't need to have any supports, printed with the hole facing the build plate. I used Anycubic Tough Resin in clear green, but I've printed the non-tough resin for shifters before, and it seemed fine. Your mileage may vary.