Thingiverse
VW Mk4 Subframe Alignment Pins
par chyrio
8
Téléchargements
5
Likes
0
Makes
Alignment pins for the Mk4 Subframe to get it straight when installing.
- One of them you can cut the head off your old bolt and thread it into the pin so its stronger..
-- Cut around 1.8" for the rear bolts and 3.3" for the front bolts.. The picture might be wrong. It wont let me delete the incorrect measurement.
-- Maybe use some loctite or epoxy when threading it in to make a permanent tool?
- The other just has m14x1.5 threads.. I found you need to be careful with this one though or print it in a way that the layer lines are horizontal with the shaft.. I snapped one off when using them on my car by tightening it to much.
KEEP IN MIND! I have CSH Subframe solid mounts installed on my car! So the rear diameter might be smaller or bigger for the bolt hole.. Would need someone to test.
- One of them you can cut the head off your old bolt and thread it into the pin so its stronger..
-- Cut around 1.8" for the rear bolts and 3.3" for the front bolts.. The picture might be wrong. It wont let me delete the incorrect measurement.
-- Maybe use some loctite or epoxy when threading it in to make a permanent tool?
- The other just has m14x1.5 threads.. I found you need to be careful with this one though or print it in a way that the layer lines are horizontal with the shaft.. I snapped one off when using them on my car by tightening it to much.
KEEP IN MIND! I have CSH Subframe solid mounts installed on my car! So the rear diameter might be smaller or bigger for the bolt hole.. Would need someone to test.
Vous avez imprimé ce modèle ? Connectez-vous et partagez votre make !
Connectez-vous pour laisser un commentaire
Se connecterPas encore de commentaires – soyez le premier !
