Thingiverse
Vyper Filament Guiding
door ProfessorBass
63
Downloads
40
Likes
0
Makes
Update 2022-07-22:
Was able to separate V2 even though glued with brute force - decided to make V3 with complete form fit.
---
Update 2022-07-21:
I made additonal V2 with form fit to be slide in from above. Some glue inside the slide rail as support is advised though.
---
Remixed the sensor holder because the filament always jumped out. So I decided enclose this better.
Result is a holder with 608 bearing with a screwable cap that prevents the filament from moving out.
Print the filament holder and glue it to the sensor holder, insert the bearing, put the filament through and screw on the cap.
Was able to separate V2 even though glued with brute force - decided to make V3 with complete form fit.
---
Update 2022-07-21:
I made additonal V2 with form fit to be slide in from above. Some glue inside the slide rail as support is advised though.
---
Remixed the sensor holder because the filament always jumped out. So I decided enclose this better.
Result is a holder with 608 bearing with a screwable cap that prevents the filament from moving out.
Print the filament holder and glue it to the sensor holder, insert the bearing, put the filament through and screw on the cap.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
