Thingiverse
W8TEE Antenna Analyzer Enclosure
por mikeyancey
5
Descargas
5
Likes
0
Makes
Many thanks for Tom HB9DOD's original Sketchup project.
I was unable to get that one to slice properly with Cura.
This remix is really just the identical project, created on TinkerCad and tested to slice on Cura 3.6.0. I've only tried to match the original project's measurements for sizes & locations exactly, from the original Sketchup files.
I was able to print on Monoprice 3D Select Mini, with about 22% Infil, and support (at 50 degree overhang) for the two little areas in the box for SO-239 connector and the little USB port on the Arduino. This broke away easily.
The lid fits snugly. There's some wiggling and (gentle) squeezing to get the cover on. I had to trim the Keyes encoder to fit.
I'll drill a hole for external power, later. That wasn't in the original project and I didn't add a corresponding hole.
I was unable to get that one to slice properly with Cura.
This remix is really just the identical project, created on TinkerCad and tested to slice on Cura 3.6.0. I've only tried to match the original project's measurements for sizes & locations exactly, from the original Sketchup files.
I was able to print on Monoprice 3D Select Mini, with about 22% Infil, and support (at 50 degree overhang) for the two little areas in the box for SO-239 connector and the little USB port on the Arduino. This broke away easily.
The lid fits snugly. There's some wiggling and (gentle) squeezing to get the cover on. I had to trim the Keyes encoder to fit.
I'll drill a hole for external power, later. That wasn't in the original project and I didn't add a corresponding hole.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!