Thingiverse
Wago 221 Junction Box
by SAKA92
4
Downloads
2
Likes
0
Makes
A small and compact junction box with three separate compartments for Wago 221’s, of any variant (2, 3 and 5). Also has two chamfered holes for securing in place with screws as shown.
The compartments have perfect friction fit for all Wago 221 sizes. The Wago's can be removed by hand (barely) or by prodding from the access holes located on the bottom side of the enclosure.
The lid is a dovetail groove with a friction fit tab situated at the front. The tolerance is enough that it’s not cumbersome at all to slide in.
Features two channels with enough clearance for several twin and earth to fit through.
Do not print in PLA. Highly recommended to print in PETG as this has a higher temperature rating.
This was all tested and printed with PrusaSlicer (2.7.1) and Prusa Mini+ (5.1.2) firmware with eSun PETG.
The compartments have perfect friction fit for all Wago 221 sizes. The Wago's can be removed by hand (barely) or by prodding from the access holes located on the bottom side of the enclosure.
The lid is a dovetail groove with a friction fit tab situated at the front. The tolerance is enough that it’s not cumbersome at all to slide in.
Features two channels with enough clearance for several twin and earth to fit through.
Do not print in PLA. Highly recommended to print in PETG as this has a higher temperature rating.
This was all tested and printed with PrusaSlicer (2.7.1) and Prusa Mini+ (5.1.2) firmware with eSun PETG.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
