Wago 222 Splicing Box

An enclosure to hold 3 Wago 222 connectors for splicing/joining two lengths of electricity cable (in this case 3 Core Heat Resistant Flexible Cable 1.5mm2). Box screws together with 3 M3 hex bolts (12mm or 14mm in length) which will provide a secure housing to avoid accidental unclipping of the connectors. Flat surfaces on the box would allow for mounting with sticky pads or double sided tape. Pictures show the box printed in a ‘hard’ TPU (72D) which would behave similarly to the Bambu TPU for AMS included in the profile. This filament was chosen for toughness and resistance to heat/chemicals. The box could also be printed in PETG or ABS/ASA. Depending on your printer, you might need to adjust the X-Y hole compensation (under the Precision sub-section of the Quality section in Bambu slicer) for right clearance - I didn't need to. NOTE: I have been informed that this is “not up to code” so use at your own risk!