Thingiverse
Wago style wire clamp
von aymaliev
1
Downloads
3
Likes
0
Makes
**KEY INSTRUCTIONS OF THE SOURCE DESIGN:**
WARNING: This will burn your house down unless you fully understand implications of the design and used materials. Provided 30V/9A rating denotes absolute maximum rather than recommended operation conditions. Do not use for high power stuff. This design is meant as proof-of-concept and might require improvements to fit it for particular use case. No warranty is provided.
Link to the source design: https://www.thingiverse.com/thing:4759369
**Differences to the source design:**
- The connecting wire (1.3mm/AWG16) is blocked on one end and now stays in place
- There is a hole for a nut or bolt (size M3) for easy attachment.
- This remix is 10mm thick, while the original design was 8mm thick. It is stronger now.
- The lever is also made stronger. The original one could easily be broken when changing positions.
WARNING: This will burn your house down unless you fully understand implications of the design and used materials. Provided 30V/9A rating denotes absolute maximum rather than recommended operation conditions. Do not use for high power stuff. This design is meant as proof-of-concept and might require improvements to fit it for particular use case. No warranty is provided.
Link to the source design: https://www.thingiverse.com/thing:4759369
**Differences to the source design:**
- The connecting wire (1.3mm/AWG16) is blocked on one end and now stays in place
- There is a hole for a nut or bolt (size M3) for easy attachment.
- This remix is 10mm thick, while the original design was 8mm thick. It is stronger now.
- The lever is also made stronger. The original one could easily be broken when changing positions.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
