Thingiverse
Walking Cane (Stick) OCTO
par 3DP_
137
Téléchargements
124
Likes
1
Makes
Hi, I Hope you all enjoy building this walking cane, it’s really strong I Made it using ESUN PLA+ and PLA BRONZE.
You must set up the printer with 50% Infill, using Support and no Raft is need it. You must chose the combination of parts that’s its best for your printer and also don’t forget to considerate your height.
For enabling its really easy you only need to remove the support and insert each part with the other, they are really tight so isn’t a bad idea to use a hammer.
For the TIP you must use a 3/4 Faucet flat Washer
https://www.youtube.com/watch?v=CO2H3-umKdc
You must set up the printer with 50% Infill, using Support and no Raft is need it. You must chose the combination of parts that’s its best for your printer and also don’t forget to considerate your height.
For enabling its really easy you only need to remove the support and insert each part with the other, they are really tight so isn’t a bad idea to use a hammer.
For the TIP you must use a 3/4 Faucet flat Washer
https://www.youtube.com/watch?v=CO2H3-umKdc
Vous avez imprimé ce modèle ? Connectez-vous et partagez votre make !
Connectez-vous pour laisser un commentaire
Se connecterPas encore de commentaires – soyez le premier !
