Thingiverse
Wall bracket for IKEA Svärta loft bed
by ndupont
11
Downloads
11
Likes
0
Makes
Sleek wall bracket for the IKEA Svärta loft bed.
It will keep the frame 4cm from the wall and prevent any movement.
*See also the anti vibration pads : https://www.thingiverse.com/thing:2796540*
Print it flat on the bed for optimal resistance. Without brim or support, with 3 perimeters (1.2mm walls) and 1.2mm top/bottom surfaces. 20% tetrahedral infill.
The bracket can be printed with 0.32mm layers, and the grommet with a 0.1mm thickness.
Print a pair of each STL, use M3 20mm hex screws with the matching nuts.
In the wall use 5mm screws with 8mm plugs.
Add an adhesive felt pad, or scrap of rubber between the main part and the bed tubes.
Some action : https://www.youtube.com/watch?v=NOQPcDJMIiU
It will keep the frame 4cm from the wall and prevent any movement.
*See also the anti vibration pads : https://www.thingiverse.com/thing:2796540*
Print it flat on the bed for optimal resistance. Without brim or support, with 3 perimeters (1.2mm walls) and 1.2mm top/bottom surfaces. 20% tetrahedral infill.
The bracket can be printed with 0.32mm layers, and the grommet with a 0.1mm thickness.
Print a pair of each STL, use M3 20mm hex screws with the matching nuts.
In the wall use 5mm screws with 8mm plugs.
Add an adhesive felt pad, or scrap of rubber between the main part and the bed tubes.
Some action : https://www.youtube.com/watch?v=NOQPcDJMIiU
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
