Wall Control - Dremel bit holder mashup

This mashup is a remix of a couple of different Dremel accessory holders along with my wall control hook modifications at https://www.thingiverse.com/thing:4097266 combined with my specific slicer settings (S3D) to not cover the honeycomb infill which i use to store the bits.

NOTE: This is not standard peg board. It is only for Wall Control slot boards.

Originally I planned on creating specific holes for each accessory tool. Not knowing future needs, I added a ton of tool holes originally. However, since each one becomes a perimeter, this significantly increased plastic and slowed down printing.

After some thought, I realized I could use the honeycomb infill and then set S3D to not put a top layer, effectively making the infill the bit holders. I also added slots to store cutting wheels, drum sander, (including small), collet, and potentially a LOT of bits depending on diameter.

Print settings are extremely important as it will not be usable unless you can use Varia