Wall Control Hook 10-HS-001

### Description

This is a hook for the [Wall Control Metal Pegboard System](https://amzn.to/2sj1OJs). This hook mimics the [10-HS-001 Hook](https://amzn.to/2H5ulXr). This is the most common and standard hook for the system. I used **pyr0ball's** design as a base for this hook.

The hook was redesigned into the left and right piece to avoid having to waste any extra plastic for supports or rafts. I then superglued the two pieces together to form the hook. The area beneath the hook has been padded slightly to reinforce the hook to provide additional support.

Works great on my Wall Control pegboard with just 15% infill! I generally bump that up higher if I am looking to hold something heavier.


### Instructions
1. Print both the left and the right pieces.
2. Superglue the two pieces to form the hook. I like to use the [gel-type superglue](https://amzn.to/2LFqTq9) since it's a lot easier to control when it's not spilling over your hands.
3. Install on [Wall Control Pegboard]