wall / desk clock we can do it!

Be sure to visit my profile page to find more fantastic models!https://makerworld.com/en/@cP3D I have created another clock here. Perhaps some of you will also like this clock.I could imagine that this clock would also make a very nice gift for someone.I have created a 170 mm and a 245 mm version for wall and table use If you wish to enthuse others about these wall clocks, please share the link on social media. Here you will only find the clock faces!The necessary accessories can be found under the following link:https://makerworld.com/en/collections/4894074 To minimize print time without compromising quality, I have configured height range modifiers in my print profiles. So don't be surprised if the swap commands do not match the data in the print profilePrint at 100% infill with a layer height of 0.06mm with a base layer of 0.12mmSwap Instructions: Start with Black At layer #19 (1.2mm) swap to Blue Gray At layer #21 (1.32mm) swap to Jade White At layer #23 (1.44mm) swap to Black