Thingiverse
Wall-E Figure
por ChaosCoreTech
1.8k
Descargas
1.7k
Likes
15
Makes
Watch here: https://youtu.be/kS-vLoGrEr4
It's time for Wall-E! Again... This time it's not a huge multi-part robot that doesn't work. It's a small figure that is now a single piece and doesn't have spots for electronics inside.
Since I already had all the individual pieces modeled, I just had to assemble them and fill any gaps or holes. After that I went through and added extras here and there to make it print easy or stronger in specific areas.
After that my wife painted it using filler primer, followed by an airbrush for the yellow area, then paintbrush using acrylic paints for the remaining colors. And to wrap it up she sprayed it with an clear coat.
Print Settings:
Printer: Da Vinci 1.0 Pro
Filament: Hatchbox PLA
Layer Height: 0.1mm
Infill: 30%
Supports: Yes
It's time for Wall-E! Again... This time it's not a huge multi-part robot that doesn't work. It's a small figure that is now a single piece and doesn't have spots for electronics inside.
Since I already had all the individual pieces modeled, I just had to assemble them and fill any gaps or holes. After that I went through and added extras here and there to make it print easy or stronger in specific areas.
After that my wife painted it using filler primer, followed by an airbrush for the yellow area, then paintbrush using acrylic paints for the remaining colors. And to wrap it up she sprayed it with an clear coat.
Print Settings:
Printer: Da Vinci 1.0 Pro
Filament: Hatchbox PLA
Layer Height: 0.1mm
Infill: 30%
Supports: Yes
ChaosCoreTech también publica en
2 modelos adicionales en 1 plataformas más
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
