Thingiverse
WALL-E Robot Replica
door chillibasket
25.5k
Downloads
22.5k
Likes
69
Makes
Few robots are more recognisable than WALL·E; his cute appearance and distinctive personality make him instantly endearing to anyone who sees him! In this project, I designed a WALL·E replica with the aim to allow each of the robot's joints to be moveable by hand or using servo motors.
Loosely based on the dimensions and design of ChaosCoreTech's Wall-E replica (https://www.thingiverse.com/thing:1681442), this version was designed from scratch in Solidworks and allows 7 of the joints to be actuated, including the arms, neck, head and eyes. The robot design has the following features:
* Each eye can be raised and lowered independently with servo motors.
* There is room in each eye to add a small camera.
* The head can look left and right using a servo motor.
* The neck is actuated at two joints, allowing the head to look up/down and to be raised/lowered.
* Each arm has a motor at the shoulder to move it up/down.
* The arms consist of pressure-fit joints, hands, and fingers,
Loosely based on the dimensions and design of ChaosCoreTech's Wall-E replica (https://www.thingiverse.com/thing:1681442), this version was designed from scratch in Solidworks and allows 7 of the joints to be actuated, including the arms, neck, head and eyes. The robot design has the following features:
* Each eye can be raised and lowered independently with servo motors.
* There is room in each eye to add a small camera.
* The head can look left and right using a servo motor.
* The neck is actuated at two joints, allowing the head to look up/down and to be raised/lowered.
* Each arm has a motor at the shoulder to move it up/down.
* The arms consist of pressure-fit joints, hands, and fingers,
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
