Wall Hooks For Your Pants

I got tired of my pants and sweaters laying on the floor. So I designed a simple three hook design to go on my wall. This design is very simple with a single back plate (modeled after a piece of wood), and three hooks that are attached to the plate with a single screw. The hooks have a mortise cut into the plate for more secure fixation of the hook to the plate. The plate has three recesses to allow for hanging from screws/nails in the wall.

**Printing**
The hooks print on their side to maximize strength in the direction of loading. No need for supports or anything more than 20% infill.

_The plate is big_ but will fit diagonally on a 400x400mm bed. No need for supports - the wall mounting screw recesses can be printed easily with bridges, the recesses for the hook screws has a sacrificial layer. To minimize material, it's recommended to use low infill, but not so low that the top layer isn't supported, leading to ripples in the surface finish. I got good results with 10% support cubi