Wall Mount for Component Drawers.

I knocked my little collection of component boxes over once. That was a pain. Besides, I want them off of my desk.

These are new boxes, with a thickened rear wall, and a slot cut in them. The slot allows for a small woodscrew to hold these mounts to a wall, and the interlocking fingers will let you hang your components to this mount.

These are the models available:
1x1x1_mount.stl: This has enough room for a 1x1x1_box in front, and it will be flush with the 1x1x2_box.

1x1x2_mount.stl: This is the same size as the 1x1x2_box.stl. Since it has a thicker rear wall, the drawer will stick out a little if you put a drawer in here (1.6mm more).

1x1x2_mount_proud.stl. This is like the 1x1x2_mount, but the front comes out that 1.6mm more. This has the same room for the drawer as the 1x1x2_box.stl, so you can just pull the other boxes forward a tad to make everything flush.

Let me know what you think. I work for comments!