Thingiverse
wall mount for lamp
von DARKTECH-DK
5
Downloads
5
Likes
0
Makes
This is a wall mount for lamps, the inner diameter is 9cm
and there is a hole on the back where the wire can be lead behind it,
so it dont hangs over the side.
Printet it with 35% infill, and its very strong
and there is a hole on the back where the wire can be lead behind it,
so it dont hangs over the side.
Printet it with 35% infill, and its very strong
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!