Wall mount for Nintendo Switch Dock

Wall mount for the Nintendo Switch and its docking station to keep device off the floor and away from dogs and other destructive entities.

Recommend 4mm diameter screw with washer. DO NOT OVER TIGHTEN (I'm guessing; I of course would never make this mistake after 16 hours of printing). Photograph is a model with 20% infill. I printed it in the orientation as it would go onto the wall to avoid need for supports. The printed model is strong enough as printed as long as the user isn't violent (are gamers violent?). Recommend between 30 - 50% infill for greater strength. If you can print it vertically that may be better for strength.

If you cannot print it vertically due to inadequate printer range in the Z-direction, you can use the split model, printing the right and left sides separately. See photograph.