MakerWorld
Organizers
Go to Model
Wall Mounted LED Remote Holder
42
Downloads
10
Likes
20
Makes
After months of losing the remote for my office LED strips I designed this wall mount to store the button remotes that come with LED strips. This can be mounted anywhere using either a single #6 (3mm shank) screw or a 3M command strip. The case is chamfered to assist with sliding the remote into the mount in the dark and the design was created to not need supports when printed vertically (honestly it would probably print fine horizontally on most printers as well, it's only a 40mm bridge when laying flat). I am using a slight brim when printing vertically on my A1 mini to assist with bed adhesion. Print time is roughly 1h07m at 0.28mm extra draft layer height using eSUN basic PLA.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
