Thingiverse
Wall-Mounted Planter
von Caseyf277
134
Downloads
140
Likes
0
Makes
This is a redesign of 3DPVDB's Wall-Flower Mount.
Tolerances have been added (.2 mm) but pieces may need to be sanded a little bit to pop in. Once you have verified that the pieces fit into the holes, seal them with waterproof glue and you are good to go.
Changes (all pieces have been redesigned):
- Pieces now fit into base instead of using hole/peg system
- More discreet nail hole
- Cloud is more symmetrical with more/smaller holes
- Cloud has larger top hole
- Pot has much more room (larger width/depth and no back)
Please post a make if you decide to print one or remix. I'd love to see it!
Tolerances have been added (.2 mm) but pieces may need to be sanded a little bit to pop in. Once you have verified that the pieces fit into the holes, seal them with waterproof glue and you are good to go.
Changes (all pieces have been redesigned):
- Pieces now fit into base instead of using hole/peg system
- More discreet nail hole
- Cloud is more symmetrical with more/smaller holes
- Cloud has larger top hole
- Pot has much more room (larger width/depth and no back)
Please post a make if you decide to print one or remix. I'd love to see it!
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
