Thingiverse
Wall Mouted Lighthouse
par pano_maniac
2
Téléchargements
4
Likes
0
Makes
Just a simple light house design I sketched up on Solidworks as a gift for my aunt.
I made this to be printed in 2 parts, Top and Bottom. To then be glued together and hung up on the wall. I made it to be printed on a 300x300 bed at 10mm thick with 8% infill and 0.2mm layer height
A full version of it is also available if anyone wants it.
I opted to print with a raft out of sheer habit and lack of patience in getting my bed adhesion just right. The gap between the raft was set to 0.35mm which made it come off very easily and super clean
Scale it to suit your own printer if necessary.
I made this to be printed in 2 parts, Top and Bottom. To then be glued together and hung up on the wall. I made it to be printed on a 300x300 bed at 10mm thick with 8% infill and 0.2mm layer height
A full version of it is also available if anyone wants it.
I opted to print with a raft out of sheer habit and lack of patience in getting my bed adhesion just right. The gap between the raft was set to 0.35mm which made it come off very easily and super clean
Scale it to suit your own printer if necessary.
Vous avez imprimé ce modèle ? Connectez-vous et partagez votre make !
Connectez-vous pour laisser un commentaire
Se connecterPas encore de commentaires – soyez le premier !
